A Bootiful Banner

Here’s the “bootiful” banner I promised; I can call it that because Sara made it! 

As you know, I don’t typically provide instructions for projects I show. If I felt like I had to do that, I would end up never posting projects! But I did want to note a couple of things about this banner.  

The stamp set and bell accents are from the Baroque Motif stamp set; it’s one of my favorites, and I’ve used it a lot this year. I stamped the swirly image on the front of each pennant, then I adhered the lace pennant on top of the card stock pennant with Sticky Strip on the back. Once I attached the lace, I adhered a one-inch black card stock strip, punched with the scallop border punch, then doused with Black Chunky glitter to finish the pennant off with a little bling.

I tied the bells (made from the circles from the pennant die) at the bottom of each pennant to the larger rhinestone brads that are attached to the pennant. I used embroidery floss to do this. (I usually use embroidery floss when I craft because thread is usually too thin, and when I do need thread, I can just use one strand of the floss.) I threaded the floss through the larger need from the Crafters’ Tool Kit. That’s also how I attached the teardrop crystals to the bell accents, as well as the fabric on the bottom. 

Finally, I created the lace accent on the front of each pennant by cutting both sizes of scallop circles out of different types of fabric (tulle, etc.), then laying them skewampous (is that a word?) on top of each other and sewing a circle in the middle of the layers, using a single strand of floss and very large stitches. Then I pulled the floss to gather the fabric, creating a layered fabric piece to put behind the letters, which you'll notice also have a little glitter bling. 
I hope that's enough insight to help you make this if you want to. I'm planning on making a banner for each of our girls!